Kingston HX426C15FBK4/16 16GB 2666MHz DDR4 Non-ECC CL15 DIMM (Kit of 4) HyperX FURY Black Series
No Longer Available
HX426C15FBK4/16
16GB (4GB 512M x 64-Bit x 4 pcs.)
DDR4-2666 CL15 288-Pin DIMM
DESCRIPTION
HyperX HX426C15FBK4/16 is a kit of four 512M x 64-bit (4GB) DDR4-2666 CL15 SDRAM
(Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA
components per module. Each module kit supports Intel Extreme Memory Profiles
(Intel XMP) 2.0. Total kit capacity is 16GB. Each module has been tested to run
at DDR4-2666 at a low latency timing of 15-17-17 at 1.2V. Additional timing
parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below.
The JEDEC standard electrical and mechanical specifications are as follows:
JEDEC/XMP TIMING PARAMETERS
JEDEC/PnP: DDR4-2666 CL15-17-17 @1.2V
DDR4-2400 CL14-16-16 @1.2V
DDR4-2133 CL12-14-14 @1.2V
XMP Profile #1: DDR4-2666 CL15-17-17 @1.2V
FEATURES
Power Supply: VDD = 1.2V Typical
VDDQ = 1.2V Typical
VPP - 2.5V Typical
VDDSPD = 2.2V to 3.6V
Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
Low-power auto self refresh (LPASR)
Data bus inversion (DBI) for data bus
On-die VREFDQ generation and calibration
Single-rank
On-board I2 serial presence-detect (SPD) EEPROM
16 internal banks; 4 groups of 4 banks each
Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
Selectable BC4 or BL8 on-the-fly (OTF)
Fly-by topology
Terminated control command and address bus
Height 1.230 (31.25mm), w/o heatsink
Specifications
CL(IDD): 15 cycles
Row Cycle Time (tRCmin): 45ns(min.)
Refresh to Active/Refresh, Command Time (tRFCmin): 260ns(min.)
Row Active Time (tRASmin): 26.25ns(min.)
Maximum Operating Power: TBD W*
UL Rating: 94 V - 0
Operating Temperature: 0oC to +85oC
Storage Temperature: -55oC to +100oC
Power will vary depending on the SDRAM used.
Name | Value |
---|---|
Capacity | N/A |
Error Checking | Non ECC |
Form Factor | DIMM |
Frequency | 2666 MHz |
Ranking | Single |
Series | HyperX Fury |
Type | N/A |
Voltage | 1.20 V |
Warranty | Lifetime |
DESCRIPTION
Document No. 4807245-001.B00 04/21/15 Page 1
SPECIFICATIONS
*Power will vary depending on the SDRAM used.
HX426C15FBK4/16
16GB (4GB 512M x 64-Bit x 4 pcs.)
DDR4-2666 CL15 288-Pin DIMM
Continued >>
kingston.com/hyperx
FEATURES
HyperX HX426C15FBK4/16 is a kit of four 512M x 64-bit (4GB)
DDR4-2666 CL15 SDRAM (Synchronous DRAM) 1Rx8, memory
module, based on eight 512M x 8-bit FBGA components per
module. Each module kit supports Intel® Extreme Memory
Profiles (Intel® XMP) 2.0. Total kit capacity is 16GB. Each
module has been tested to run at DDR4-2666 at a low latency timing
of 15-17-17 at 1.2V. Additional timing parameters are shown in
the Plug-N-Play (PnP) Timing Parameters section below.