HyperX HX424C15FW2K2/16 is a kit of two 1G x 64-bit (8GB)
DDR4-2400 CL15 SDRAM (Synchronous DRAM) 1Rx8, memory
module, based on eight 1G x 8-bit FBGA components per module.
Each module kit supports Intel® Extreme Memory Profiles
(Intel® XMP) 2.0. Total kit capacity is 16GB. Each module has
been tested to run at DDR4-2400 at a low latency timing of 15-15-15
at 1.2V. Additional timing parameters are shown in the
Plug-N-Play (PnP) Timing Parameters section below.

Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 1.340” (34.04mm), w/heatsink