Kingston Hyperx Fury 8gb (2x4gb) Ddr4 Udimm 2666mhz Cl15 1.2v Unbuffered Valueram Double Stick
No Longer Available
QUICK OVERVIEW
HyperX FURY DDR4 Memory
Auto-overclocking for X99 platforms.
HyperX® FURY DDR4 can handle even the toughest battle. It recognizes its host platform and overclocks to the highest frequency published (up to 2666MHz*) — so you can wreak havoc. FURY DDR4 runs at 1.2V, even at 2666MHz, so it stays cooler while you play. You don't need to alter the voltage to reach higher speeds, which means there's more power for other hardware in the system. FURY's sleek, asymmetrical black heat spreader provides enhanced thermal dissipation to help keep your cool and help you stand out from the crowd.
- Automatic overclocking — up to 2666MHz
- Low power consumption at 1.2V
- Optimized for X99 series motherboards
- Stylish low profile heat spreader in black
Plug and Play
HyperX FURY DDR4 is the first product line to offer automatic overclocking up to the highest frequency published. Get the speed you want, without a hassle.
Optimized for Intel's X99 chipset
Complete your new X99 system with the latest generation of DRAM technology — DDR4 memory. HyperX FURY DDR4 memory is optimized for X99 motherboards for compatibility and easy overclocking.
Lowest power consumption
DDR4's lower power requirements mean less heat and higher reliability. Low 1.2V draws less power from your system for a cooler and quieter PC.
Low-profile stylish heat spreader
FURY's asymmetrical signature heat spreader is available in black with matching black PCB. It complements most X99 motherboards and its low-profile heat spreader fits under oversized CPU coolers while enhancing heat dissipation for lasting reliability.
HyperX HX426C15FBK2/8 is a kit of two 512M x 64-bit (4GB) DDR4-2666 CL15 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components per module. Each module kit supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Total kit capacity is 8GB. Each module has been tested to run at DDR4-2666 at a low latency timing of 15-17-17 at 1.2V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 1.340” (34.04mm), w/heatsink
